Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
blocks:app-note:nexmosphere [2021-04-21 12:29] mattias [Program RFID tags to be used with Nexmosphere RFID sensors] |
blocks:app-note:nexmosphere [2023-12-20 13:21] mattias [Use Nexmosphere sensors and actuators with Blocks] |
||
---|---|---|---|
Line 1: | Line 1: | ||
======Use Nexmosphere sensors and actuators with Blocks====== | ======Use Nexmosphere sensors and actuators with Blocks====== | ||
- | This is an application note that describes how to get started using Nexmosphere sensors and actuators with experiences managed by Blocks. | + | |
+ | This is an application note that describes how to get started using Nexmosphere sensors and actuators with experiences managed by Blocks. | ||
+ | |||
+ | :!: The method in this application note is useful if connecting a Nexmosphere controller with a 3.5mm serial connector using a serial network server such as Moxa N-Port. From Blocks version 6.1 it is possible to connect a Nexmosphere with built-in serial to usb controller directly to Pixilab Players USB port. Please consult the manual for more details about serial devices in blocks. | ||
=====Hardware requirements====== | =====Hardware requirements====== | ||
Line 7: | Line 10: | ||
In the examples we use the following hardware: | In the examples we use the following hardware: | ||
- | Nexmosphere | + | * [[https:// |
- | + | | |
- | XN-180 Experience controller | + | |
- | + | | |
- | XT-EF650 Gesture sensor | + | |
- | + | | |
- | XR-DR1 RFID Pick up sensor | + | |
- | + | ||
- | XW-L9 X-WAVE animating led strip | + | |
- | + | ||
- | + | ||
- | Moxa | + | |
- | + | ||
- | [[https:// | + | |
- | + | ||
- | 3.5mm to dsub cable that connects the XN-180 to the Moxa Nport. | + | |
Line 152: | Line 145: | ||
{{: | {{: | ||
- | A valid tag ID has to be between 1-255, 01-ff in hex. | + | A valid tag ID has to be between 1-255, 01-FF in hex. |
In the screenshot below where i read a tag already programmed as tag ID 3, 03 in hex is repeated in all 16 bytes in sector 1 block 0. | In the screenshot below where i read a tag already programmed as tag ID 3, 03 in hex is repeated in all 16 bytes in sector 1 block 0. | ||
{{: | {{: | ||
- | |||
If I want to program a new tag with no 255 I would set the application to write tag mode with the following settings and press the write tag button while holding the tag to the mobiles NFC sensor: | If I want to program a new tag with no 255 I would set the application to write tag mode with the following settings and press the write tag button while holding the tag to the mobiles NFC sensor: | ||
- | {{: | + | {{: |
+ | |||
+ | This should be the final result from reading the tag with ID 255. | ||
+ | {{: |